Publicidad
Idiomas disponibles
Idiomas disponibles
Care & Maintenance
Brush
* Weekly cleaning is recommended.
1. Flip the vacuum-mop over and pinch the clips to remove the brush
cover.
2. Lift the brush out of the vacuum-mop, then clean the brush bearings.
3. Use the included brush cleaning tool to remove any hairs tangled on
the brush.
4. Reinsert the brush, then put the cover back on and press on it until the
clips lock into place.
Note: It is recommended to clean the brush weekly and replaced every 6 to 12 months.
15
Using the Brush Cleaning Tool
Note: If too much hair is tangled in the brush, or if the hair is tightly tangled, do not
forcibly pull on it, as this could damage the brush.
Brush Cover
Omnidirectional Wheel
Clips
Brush
1. Flip the vacuum-mop over
and pull out the omnidirectional
Brush Bearings
wheel.
2. Remove hair, dirt, and other
debris from the wheel and axle.
3. Reinsert the wheel and press it
firmly back into place.
Notes:
· A small screwdriver or other pry tool
can be used to gently pop out and
remove the wheel.
· The wheel can be cleaned with water
and reinstalled after drying.
* Clean it as needed.
Wheel
Axle
Holder
Publicidad
