Publicidad
Idiomas disponibles
Idiomas disponibles
11 Specifications
Ninebot S-Max
Model
Product
Dimensions
Payload
Weight
Net Weight
Age
Rider
Height
Max. Speed
Typical Range
[2]
Max. Slope
Machine
Traversable Terrain
Parameters
Operating Temperature
Storage Temperature
IP Rating
Charge Time
Nominal Voltage
Max. Charging Voltage
Battery
Nominal Capacity
Charging Temperature
Battery Management System
Nominal Power
Motors
Max. Power
Input Voltage
Output Voltage
Charger
Nominal Power
Output Current
Tire
Tire
[1] The two values in brackets are the lowest distance from the ground to the highest part of the mainframe.
[2] Typical Range: tested while riding under full power, 165 lbs (75 kg) load, 77°F (25°C), 60% of max. speed on average on
pavement.
* Some of the factors that affect range include: speed, number of starts and stops, ambient temperature, etc.
36
N3M432
10.3 × 22.8 × (25.4–37.6) in / 262 × 578 × (645–955) mm
88.2–220 lbs / 40–100 kg
Approx. 46.3 lbs (21 kg)
16–60 years old
51.2–78.7 in / 130–200 cm
Approx. 12.4 mph (20 km/h)
Approx. 23.6 mph (38 km)
Approx. 15 °
Pavement, packed dirt, slopes < 15 °, obstacles < 0.4 in (1 cm), gaps < 1.2
in (3 cm)
14–104°F (-10–40°C)
-4–122°F (-20–50°C)
IP54
4 hours
55.5 V DC
59.5 V DC
432 Wh
32–104°F (0–40°C)
Over-voltage, under-voltage, short circuit, and over-heating protection. Auto-sleep and
auto-wake.
500 W × 2
2400 W × 2
100–240 VAC
59.5 VDC
120 W
2 A
Tire width: 2.7 in (68 mm); 10 × 2.75 in, hollow solid tire
12 Certifications
This product is certified to ANSI/CAN/UL-2272 by TUV Rheinland.
The battery complies with UN/DOT 38.3.
The battery complies with ANSI/UL 2271.
[1]
Federal Communications Commission (FCC) Compliance Statement for USA
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Cet équipement est conforme aux limites d'exposition aux radiations de la IC définies pour un environnement non
contrôlé. Cet équipement doit être installé et utilisé à une distance minimale de 20 cm entre le radiateur et votre corps.
Industry Canada (IC) Compliance Statement for Canada
This device complies with Industry Canada license-exempt RSS standard (s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
CAN ICES-3 (B)/NMB-3(B)
"Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement."
Neither Segway Inc. nor Ninebot is responsible for any changes or modifications not expressly approved by Segway Inc.
or Ninebot. Such modifications could void the user's authority to operate the equipment.
FCC ID: 2ALS8-PS0002
IC: 22636-PS0002
37
Publicidad
