Descargar Imprimir esta página

Quattro QUATTRO600 Manual De Instrucciones página 14

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 89
Introduction
Thank you for choosing this caravan mover. This product has been produced according to very high
standards and has undergone careful quality control procedures. Simply by using the remote control
you can move your caravan effortlessly into any position required within operating guidelines.
Before proceeding with installation and starting to use the mover, please read this manual very
carefully and be aware of all the safety instructions! The owner of the caravan will always be
responsible for correct use. Keep this manual inside your caravan for future reference.
This User Manual covers three models of Caravan Mover: Model No. QUATTRO500, Model No.
QUATTRO600 and Model No.EGO500; any installation or operational differences between the two
models are detailed where appropriate.
The caravan movers consist of two 12V motor-powered rollers, a 12V electronic control box and a
remote control. To function,
the motor-powered rollers must be engaged against the tyres of your caravan. The supplied cross
actuation device (QUATTRO500 ONLY) enables you to engage both rollers at the same time from one
side of your caravan. Once this is done, the mover is ready for operation. The remote control will allow
you to move your caravan in any direction.
Please be aware that certain installations in Germany are subject to further technical requirements
than in the rest of Europe. If after installation the caravan mover has easily accessible exposed
sharp edges not covered by the caravan bodywork, it is likely that an additional cover will need to be
installed. Please contact Purple Line for further assistance and see 'Optional fitting adapters' where
these optional covers are listed with installation explained.
Fitting Guidelines
The chassis clamps provided are suitable for fitment onto most standard caravan chassis that have
an L-shape or U-shape profile. Please refer to Fig.11 & Fig.12 for reference on dimensions and
clearances BEFORE you proceed any further with installation. If your chassis has different dimensions
to those shown in Fig.12 then various chassis clamp adapters are available to suit the majority of UK
and Continental caravans; please refer to the section entitled 'Optional Fitting Adapters'.
Specification
Model Number
Operational Voltage
Average Current Consumption*
Maximum Current Consumption**
Speed
Approx. Net Weight (inc. all fixings and
accessories)
Safe Working Load (SWL) Twin Motor/Quad
Motor
Minimum Width (caravan/trailer)
Maximum Width (caravan/trailer)
Power Source (caravan leisure battery)
* Average Current Consumption readings when using an approx. 1100kg single axle caravan on a hard, level surface.
** Maximum Current Consumption readings when using an approx. 1100Kg single axle caravan ascending a 1:4 (25%) gradient.
QUATTRO600 / QUATTRO500
12 Volt DC
20A (approx.)
120A
12cm/s (approx.)
29kg (approx.)
2500kg / 3500kg
1800mm
2500mm
12V
14 EN
EGO500
12V DC
25A (approx.)
120A
12cm/s (approx.)
31kg (approx.)
2250kg / 3500kg
1800mm
2500mm
12V

Publicidad

loading

Productos relacionados para Quattro QUATTRO600

Este manual también es adecuado para:

Quattro500Ego500