Descargar Imprimir esta página

Quattro QUATTRO600 Manual De Instrucciones página 20

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 89
Optional Fitting Adapters
Additional chassis clamp adapters shown below are available for purchase:
Low Profile Chassis Adapter Plates (Part No. CM-029)
If your chassis frame height is less than 140mm these plates must be fitted to lower the
assembly to provide the correct height of 185mm. Drilling of your chassis may be required.
Note: In some countries, the installation must be checked by a professional technician in order
to adhere to local regulations.
Narrow Gauge Chassis Adapters (Part No. CM-030)
These plates must be utilised if you have an AL-KO Vario III/AV chassis which has a frame
thickness of less than 2.8mm. These must be positioned behind the axle using pre-drilled holes
already available on the chassis; so your mover must be fitted behind the axle.
16mm Spacers - 1 pair (Part No. CM-028/Q)
Use spacers to lower the mover assembly if your chassis has a frame height of between 140
to 185mm. A maximum of 3 sets of spacers can be utilised to achieve correct frame height of
185mm. A set of extended clamp bolts must be used in conjunction with these spacers (Part
No. CM-031).
[For use with Classic Clamp only.]
Set of 8 M10 x 100 Bolts (Part No. CM-031)
Set of 8 extended clamp bolts for use with 16mm spacers.
[For use with Classic Clamp only.]
Quattro500/600 Cover
(Part No. QTX10009 [LH] QTX10010 [RH])
Plastic cover for use in certain installations subject to further
technical requirements in Germany. If after installation the caravan
mover has easily accessible exposed sharp edges not covered by
the caravan bodywork, it is likely that this additional cover will need
to be installed.
Please contact Purple Line for further guidance and installation
detail.
EGO400/500 Cover
(Part No. QTX10006 [LH] QTX10007 [RH])
Plastic cover for use in certain installations subject to further
technical requirements in Germany. If after installation the caravan
mover has easily accessible exposed sharp edges not covered by
the caravan bodywork, it is likely that this additional cover will need
to be installed.
Please contact Purple Line for further guidance and installation
detail.
20 EN

Publicidad

loading

Productos relacionados para Quattro QUATTRO600

Este manual también es adecuado para:

Quattro500Ego500