HOMCOM 370-238V90 Manual Del Propietário página 22

1
Insert the rear bumper support frame
under the body, fasten it with 9 screws.
3
Step1
Assemble all the parts in sequence as
picture shown. Insert a pin to the hole of
the rear axle and make it to"M "shape by
a plier. Repeat the process for the other
side.
Assembly
Φ4x12mm
Step2 Step3
Washer x4 Pin x2
2
Step1
Assemble all the parts in sequence as
picture shown, that is, slide the washer
facing inward onto the front axle, front
wheel, washer, then insert a pin to the
hole of the front axle and make it to
"M"shape by a plier.
4
5
"Snap " a hubcap into the center. Repeat
the Process for the other side.
Plug connectors. Place the steering wheel
onto the turning shaft and fasten it with
bolt and nut.
22
Step2 Step3
Washer x4 Pin x2
M
J