Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
If your monitor cannot work normally, please refer to the following methods for
common problems quickly, if you need assistance, please call the dealer where
you purchased the Monitor.
A. There is no Screen Image / LED no light
Please check to see whether the power cord is securely connect to the monitor
and wall outlet, and whether the display is in power saving mode.
B. There is no Screen Image / LED light red
Check whether the display card of PC is loosed, and check the connection between
signal cables and display
C. The display is not clear or the image is too large or too small
Enter the OSD image adjustment menu, and then select "Auto Adjust" to make the
display to adjust automatically to optimum.
D. The image is too light or too dark
Enter the OSD brightness adjustment menu, and then select "UP / DOWN" to adjust
the brightness and contrast to optimum.
E. The screen is overheated
Please keep at least 5cm around the display for ventilation, and do not place
anything on the monitor.
F. Dark display after the power ON / FACULA
This is normal. Due to the temperature difference, the backlight will not give out
light equably at the beginning of the powering on, but the backlight lamp will come
to normal work after 20 minutes, the darkness and facula will disappear at this
time.
G. The image is distorted, blinks and flashes
Check the computer in its entirety, for loose wires; choose the appropriate
resolution to your monitor.
Publicidad
