Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTMENT
Check that the net pressure is between 8 and 9
bar (indicated in green in the net pressure gauge
scale). If not, the pump screw should be adjusted as
shown in the figure, to obtain the desired net pressure
(clockwise to decrease pressure, and counter-
clockwise to increase pressure).
When the pressure inside the boiler gets to the working regime (1 Kg/cm²,
shown in red in the boiler pressure gauge scale), the pressure stat stops,
and the red pilot turns off, indicating that the
machine is ready to work. If the red pilot is still
on, or if it turned off before arriving to the
working regime, it is neccessary to set the
pressure stat, by adjusting the screw as shown in
the left figure.
accessed by removing the cup tray.
ready to work, pouring coffee, hot water and
steam.
The pressure stat can be
Now the espresso coffee machine is
PROGRAMMING THE DOSAGE. (EP-C Model)
To obtain the dosages that meet your needs, you should follow the
following steps:
1.
Place a cup under the group you wish to
program, taking care that the water pours inside the cup. For
this process, we recommend that you use the filter holder
with a single spout.
2.
Press the programming button (indicated with a star or
asterisk) for 5 seconds. This will make the led to start blinking.
3.
Press the button you want to program, and water will
begin to pour. Once the desired dosage has been obtained, press the
button again. This will stop the water pour and turn off the led, indicating a
correct programming. Wait 10 seconds so that the microprocessor can
store the dosage.
4.
Repeat steps 2 - 3 for the remaining buttons.
5.
If you want the same program for all groups, it should be
Publicidad
