Publicidad
Idiomas disponibles
Idiomas disponibles
done in the leftmost group. Wait 10 seconds so that the changes can be
stored in all groups.
6.
To obtain a different program in each group, you should
begin with the leftmost group and continue with any of the other groups.
SWITCH FROM ELECTRONIC (AUTOMATIC) TO SEMI-
AUTOMATIC MODE
To change from Electronic (microprocessor-controlled) to Semi-
Automatic mode, the machine is provided with a switch, that can be
accessed by removing the cup tray.
To change the working mode to
Semi-Automatic, set the switch lever
to the upper position, as shown in the
previous figure. From this moment,
the microprocessor functions will stop, and should be done manually, i.e.:
a.- To load water in the boiler, press the Water Load Push-Button
located in the machine's front.
b.- To pour coffee, press the buttons located to the right of the
automatic dosing buttons. Stop the pour by pressing them again.
MAINTENANCE.
Every day, at the end of the work, clean all the groups. To do this,
put the small bowl provided with the machine in the filter holder. Make
water flow inside the group for 1 minute, and then stop the flux to allow
the water to be eliminated through the drainage tray. Repeat this process
3 or 4 times for each group.
Finally, cut the external power supply, remove the filter holders from
the groups, and clean the steam and hot water wands, filters and external
parts of the machine.
Regularly check the groups, pump, filters and purifiers (if any), and
all the security and control elements.
! IMPORTANT:
In order to obtain the maximun benefit from your machine, we
recommend that all check-ups and repairs are performed by our authorized
TECHNICAL ASSISTANCE SERVICE.
Publicidad
