Publicidad
8 Conecta el extremo del anillo grande del cable de 12 V
9 Vuelve a colocar la cubierta del terminal en el dispositivo y apriétala.
Using the Heat-Shrink Crimp Connectors
You should use the included heat-shrink crimp connectors to make a water-tight connection between the bare
wires.
Only use the heat gun to apply heat to the heat-shrink crimp connectors in a well-ventilated area. Do not use the
heat gun near clothing or bare skin. Doing so can result in property damage or serious injury.
1 Using wire strippers, strip 6 mm (
2 If necessary, twist the strands of each wire
3 Insert one bare wire into one end of the heat-shrink crimp connector
The bare wires are not secure until they are crimped and sealed.
4 Insert the corresponding bare wire into the other end of the heat-shrink crimp connector.
5 Using pliers, crimp both sides of the center of the connector
6 Using a heat gun, apply heat to the heat-shrink crimp connector until the connector is sealed to the wires.
Do not apply heat to the wires directly.
Apéndice
ADVERTENCIA
1
/
in.) off the end of each bare wire.
4
clockwise to bundle them together.
al terminal positivo de la batería del vehículo.
.
to secure the connection.
71
Publicidad
