Lindy 38344 Manual De Usuario página 7

User Manual English
Installation and Operation
Transmitter Front and Rear
1- POWER LED: Indicates Power.
2- LINK LED: This will illuminate when the connection between transmitter and receiver is active; this will
flash when the units are in low power mode.
3- VIDEO LED: This will illuminate if the video is encrypted; this will flash if the video is not encrypted.
4- ARC LED: This will illuminate when the ARC function has been switched on, it remains off if it's on
TOSLINK mode.
5- TOSLINK LED: This will illuminate when the TOSLINK function has been switched on, it remains off if
it's on ARC mode.
6- SELECT button: Push the button to switch between ARC and TOSLINK mode.
7- 3.5mm IN/OUT switch: Switch left to set the 3.5mm audio port as audio embedding port, switch right to
set it as audio de-embedding port.
8- LOOP OUT/AUDIO ONLY switch: Switch left to set the HDMI OUT port as loop out port to connect a
local HDMI display; switch right to get the audio signal on the HDMI OUT port from ARC or TosLink, a
black screen 720p video signal is displayed.
9- HOST/DEVICE USB switch: Switch left to enable the USB HOST mode and connect a source to USB
HOST port using a USB Type A-B cable; switch right to enable the USB DEVICE mode and connect USB
peripherals to USB DEVICES ports.
10- USB DEVICES: Connect to a mouse, keyboard or other USB devices.
11- USB HOST: Connect to a USB source device.
12- SERVICE: Reserved for future use.
13- 24V DC: Connect the 24VDC 1A PSU to an AC wall outlet and securely connector to the transmitter
or receiver. This is only required at one side of the installation.
14- ETHERNET: Connect to an Ethernet hub or router using standard Cat.6 or above cable.