Haier JG45B Manual De Instrucciones página 6

 Before Using Your Wine cooler
• Remove the exterior and interior packing.
• Before connecting the Wine cooler to the power source, let it stand upright for approximately 2 hours. This
will reduce the possibility of a malfunction in the cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• When disposing your appliance, please choose an authorized disposal site.
 Installation of Your Wine Cooler
• This appliance is designed to be for free standing installation or built-in (fully recessed) (Refer to sticker
location the back of this appliance).
This appliance is intended to be used exclusively for the storage of wine or beverages.
•
• Place your Wine cooler on a floor that is strong enough to support it when it is fully loaded. To level your
Wine cooler, adjust the front leveling leg at the bottom of the Wine cooler.
This appliance is using flammability refrigerant.So never damage the cooling pipework during the
•
transportation.Locate the Wine cooler away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
Extreme cold ambient temperatures may also cause the unit not to perform properly.
Avoid locating the unit in moist areas.
•
Plug the Wine cooler into an exclusive, properly installed-grounded wall outlet. Do not under any
•
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power
and/or grounding should be directed toward a certified electrician or an authorized Products service center.
 Attention
• Store wine in sealed bottles;
Do not overload the cabinet;
•
Do not open the door unless necessary;
•
Do not cover shelves with aluminum foil or any other shelf material which may prevent air circulation;
•
Should the Wine cooler be stored without use for long periods it is suggested, after a careful cleaning, to leave
•
the door ajar to allow air to circulate inside the cabinet in order to avoid possible formations of condensation,
mold or odors.
 Ambient Room Temperature Limits
This appliance is designed to operate in ambient temperatures specified by its temperature class marked on the rating
plate.
Class
Extended Temperate
Temperate
Subtropical
Tropical
INSTALLATION INSTRUCTIONS
Symbol Ambient Temperatures range
+ 50℉ to + 90℉(+
SN
10℃ to + 32℃)
+ 60℉ to + 90℉(+
N
16℃ to + 32℃)
+ 60℉ to + 100℉
ST
(+ 16℃ to + 38℃)
+ 60℉ to + 110℉
T
(+ 16℃ to + 43℃)
4
EN