Oursson CM0400 Manual De Instrucciones página 12

CLEANING AND MAINTENANCE, Рiс. E
Clean all the parts of the device immediately after
use.
• Unplug the device and let it cool completely. Lightly press
the anti-drip valve 3-4 times, to drain all the water. Jug with
lid, filter, measuring spoon, water tank and inner lid wash
with warm water and detergent. You cannot wash coffee
maker's parts in the dishwasher, besides jug with lid.
• If necessary, clean the filter with soft brush, Рiс. D-9.
• Wipe the body of the device with damp cloth, Рiс. D-8.
Wipe the heating plate surface with dry soft cloth.
• Never immerse the body of the device into the water to
avoid electric shock.
• After cleaning, thoroughly dry all elements of the device.
POSSIBLE PROBLEMS AND SOLUTIONS
Possible Problem
Device doesn't turn on
Device isn't working
When using coffee
grinder coffee is not
strong.
Coffee continues to drip
after preparation.
Coffee isn't hot
enought.
PRODUCT CERTIFICATION
For information on product certification, see http://www.oursson.com or ask seller for a copy.
Specifications
Model
Power consumption, W
Rated voltage
Class of protection against electrical shock
Storage and transportation temperature
Operating temperature from
Humidity Requirements
Dimensions, mm
Weight, kg
*Products should be stored in dry, ventilated warehouses at temperatures below - 25°C.
Only a qualified specialist of an authorized service center OURSSON AG can repair the juice maker.
12
Possible Cause
• No voltage in the socket.
• No water in the tank.
• The lid of the device isn't closed.
• "Drop-stop" system is clogged.
• Scale has formed.
REMOVING SCALE
It is recommended to clean the coffee maker from scale
approximately once every two months. It is recommend-
ed using special detergents for cleaning coffee makers.
1. Fill the water tank to the MAX with water and special
detergents for cleaning scale (see instructions). You
may also use lemon acid. For this, it is necessary to
mix 0,5 l. of water and 2 tablespoons of lemon acid.
2. Place the glass jug onto the heating plate.
3. Make sure the filter and inner lid are installed correct-
ly. No coffee.
4. Plug in the device. button indication will lit.
5. Turn the switch into the
6. When the water is drained, turn off the coffee maker
and leave the solution for 15 minutes. Then pour the
solution out of the jug. Repeat steps 1-6 about 3-4
times.
7. Pour clean water into the container. Repeat steps 1-6
with clean water 2 times.
8. Rinse the jug with a lid, filter, water tank and inner
lid, Pic. E.
Solutions
• Unplug the device and wait until the voltage
recovers.
• Fill the water tank to the MAX.Turn off the
device and turn it back on after 10-20 seconds.
• Close the lid.
• Use coffee beans of stronger varieties or with a
more intense flavor.
• Make sure that the number of cups selected
matches the amount of water in the container.
• Wash the water tank and coffee container, as
well as the «drop-stop» system.
• Before brewing coffee, rinse the jug with hot
water.
• Clean the device from scale.
CM0400G
Max 900
220-240 V~; 50-60 Hz
I
- 25°C to + 35°C
+5°C to + 35°C
15-75% without condensate
250x160x290
2,92
position. Press button.