Ryobi RYi150C Manual Del Operador página 9

 Insert a battery pack into the power source.
 Press and hold the power button (
turn the power source ON. The LED will light up green
when ready to use.
 Plug devices you want to power or charge into the power
source's USB ports and/or 120 volt receptacle.
 If the power button LED blinks red then turns off, the
power source may be overloaded. Disconnect your
device, make sure your battery pack is sufficiently
charged to power your device, then press the button
to turn the power source back on. Reconnect your
device and try again. If the fault condition immediately
reoccurs, the item being powered exceeds the capacity
of the power source.
 If the power button LED turns red but does not shut
down the power source, the power source is overheated.
Allow the unit to cool until the LED turns green, then
try again.
 If the power button LED flashes yellow, the battery
pack needs to be recharged.
 To use the worklight, press the light button (
the light button again to turn the worklight off.
OPERATION
) for 1.5 seconds to
 When finished, disconnect your device and press the
NOTE: When needed, an internal cooling fan will run to
regulate the unit's operating temperature. If running, always
wait for the fan to stop before you disconnect the battery
pack from the power source.
USING THE POWER SOURCE TO CHARGE
YOUR 18V BATTERY
See Figure 3.
Plug either end of a USB-C charging cable into a RYOBI USB
wall adaptor and plug the other end into the power source
to begin charging your RYOBI 18V battery. For best results,
use a USB-C wall adaptor, rated up to 30W. This device will
also charge when connected with a USB-C to USB-A cable
(not included). Any USB port with supplied power can charge
your RYOBI 18V battery, including USB ports in vehicles,
boats, or solar panels.
). Press
NOTE: The inverter will only charge the battery when receiv-
ing power through the USB-C port.
7 — English
NOTE: The power source must be on for the worklight
to function.
power button indicator (
off the power source.
) again for 1.5 seconds to turn