Disposal; Manufacturer's Warranty - Tools - Hilti TE DRS-BK Manual De Instrucciones

Fault
Excessive dust emission.
Dust module falls off.
Dust module can not be re-
moved.
The industrial vacuum cleaner
makes a permanent beeping
sound.
Side grip not fitted to unit.

9. Disposal

Most of the materials from which Hilti tools or appliances are manufactured can be recycled. The materials must
be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements
for taking back old tools and appliances for recycling. Ask Hilti customer service or your Hilti representative
for further information.
The drilling dust collected must be disposed of in accordance with the applicable national regulations.

10. Manufacturer's warranty - tools

Hilti warrants that the tool supplied is free of defects
in material and workmanship. This warranty is valid
so long as the tool is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti Operating Instructions, and the technical
system is maintained. This means that only original
Hilti consumables, components and spare parts may
be used in the tool.
This warranty provides the free-of-charge repair or
replacement of defective parts only over the entire
lifespan of the tool. Parts requiring repair or replace-
Printed: 07.07.2013 | Doc-Nr: PUB / 5071246 / 000 / 00
Possible cause
Distance between percussion core
bit and suction tube too wide.
The dust module had not been fit-
ted correctly.
Main unit, power tool neck are oily
and greasy.
Side grip not fully tightened.
Side grip broken.
Side grip clamping band not suffi-
ciently opened.
The dimples on the bellows are
worn.
Substantial force used to separate
the side grip from the main unit.
ment as a result of normal wear and tear are not
covered by this warranty.
Additional claims are excluded, unless stringent
national regulations prohibit such exclusion. In
particular, Hilti is not obligated for direct, indir-
ect, incidental or consequential damages, losses
or expenses in connection with, or by reason of, the
use of, or inability to use the tool for any purpose.
Implied warranties of merchantability or fitness for
a particular purpose are specifically excluded.
Remedy
Use only Hilti percussion core bits.
Fit the dust module according to
the operating instructions. Main
unit must be fitted in the intended
position.
Remove oil and grease from the
unit and outer surfaces with a
cleaning cloth.
Fully tighten the side grip.
Fit a new side grip.
Undo the grip further, i.e. the
clamping band opens more.
Replace the bellows.
Fit both parts together. Check the
fitting direction of the side grip.
en
15