Publicidad
Idiomas disponibles
Idiomas disponibles
Installation steps
ATL-FW-304
1. Remove mounting hardware from
faucet body shank.
2. Slide the Escutcheon (1) over the shank.
Make sure the Rubber Washer (2) is
positioned in its seat in the Escutcheon
(fig. 2A).
2A
1
2
3. Place the faucet in the hole, orienting
the spout towards the sink bowl
with the handles in position to rotate
forward.
4. Install mounting hardware underneath
the mounting surface in the following
order: Rubber Washer (3), Press Plate (4)
and Fixing Nut (5) (fig. 2B).
2B
3
4
5
5. Connect the cold water supply to the
faucet:
– Screw in 3/8" Push Fitting (6) into
Mounting Shank (7) (fig. 2C).
Hand tighten only!
2C
7
6
Warning: Use of tools to tighten this
fitting can lead to leaks!
– Insert the 3/8" Poly-tube into the Push
Fitting (fig. 1A, 1B).
Note: There should be a service label
attached to the poly-tubing. Do not
remove label.
6. Connect the 3/8" poly-tube to the
outlet of the filtration system as
outlined in the filtration system
instructions.
7. Turn on the water and check for leaks.
7
EN
Publicidad
