Truper TAL-3/8N2 Manual
Ocultar thumbs
Ver también para TAL-3/8N2:
- Manual de instrucciones (24 páginas) ,
- Guia de inicio rapido (12 páginas)
Manuales relacionados para Truper TAL-3/8N2
Resumen de contenidos para Truper TAL-3/8N2
- Página 1 Manual Drill 0.6 Hp 3/8” Power Chuck Applies for: Code Model 16706 TAL-3/8N2 TAL-3/8N2 Read this manual thoroughly CAUTION before using the tool.
- Página 2 Manual before Parts using the tool. Preparation Keep this manual for future references. Start up The illustrations in this manual are for reference Maintenance only. They might be different from the real tool. Notes Authorized service centers Warranty policy TAL-3/8N2 ENGLISH...
- Página 3 Technical data TAL-3/8N2 Code 16706 Description Drill Chuck 3/8” Voltage 127 V Frequency 60 Hz Current 3.15 A Power 0.6 Hp Speed 0 RPM - 3 000 RPM Drilling Capacity Metal: 3/8” | Wood: 3/4” Duty cycle 50 minutes work per 20 minutes idle.
- Página 4 General power tool safety warnings WARNING! Read carefully all safety warnings and instructions listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references.
- Página 5 Safety standards for drills Choose the right bit While operating the drill CAUTION • Choose the right bit for the work piece. • Use the auxiliary handles, if supplied with the tool. It reduces the risk of severe injury and makes the job easier. Loss of control may result in personal injury.
- Página 6 Parts Chuck Handle Lock-on Variable speed button Forward / reverse control trigger control lever Power cord Switch Chuck Chuck wrench wrench holder Power cord guard ENGLISH...
- Página 7 Preparation Chuck Bit fitting • Put the bit into the chuck until it stops. Fasten with the chuck wrench and tighten alternatively the chuck into each of the orifices. WARNING Clean burrs and any other foreign objects from the drill bit and drill bit, otherwise the drill bit may not be tight and cause serious personal injury.
- Página 8 Maintenance Chuck Change • Remove the auxiliary handle and open wide the chuck jaws. • Using a screwdriver remove the left-threaded safety screw with a clockwise movement. Phillips • Fit the long side of an “L” (not included) Allen key in a Screwdriver vise and insert the short side of the “L”...
- Página 9 Notes ENGLISH...
- Página 10 Notes ENGLISH...
- Página 11 Authorized service centers In the event of any problem contacting a Truper Authorized Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers 800 690-6990 or 800 018-7873 to get information about the nearest Service Center.
- Página 12 ® require any proof of purchase to make the warranty effective. Phone number 800-018-7873. Made in China. Imported by Truper, S.A. de C.V. Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec, Edo. de Méx. C.P. 54257, Phone number 761 782 9100.