Truper TAL-3/8N2 Manual página 7

Preparation
Bit fitting
• Put the bit into the chuck until it stops. Fasten with the
chuck wrench and tighten alternatively the chuck into
each of the orifices.
WARNING
Clean burrs and any other foreign
objects from the drill bit and drill bit, otherwise the drill
bit may not be tight and cause serious personal injury.
Start up
Start up and operation control
• Intermittent operation:
Connect the plug into the power outlet.
Press the switch (A) to start the drill.
To stop, just release the switch.
• Continuous operation:
Connect the plug into the power outlet.
Press the switch (A) and block it pressing the lock-on button (B).
To stop, press and then, release the switch.
Speed control
• The tool can operate in different speeds. These can be selected adjusting the
speed control (C). Turn the speed control in a clockwise direction to increase the
Drill speed. Turn in a counterclockwise direction to decrease speed.
Rotation direction
• The direction of rotation of the drill is controlled by the rotation selector lever (D).
With this function you can use the tool as a screwdriver.
• In order for the bit to rotate forward and drill, move the rotation selector lever (D)
to the right side of the trigger (letter R).
• To rotate the tool in reverse and use it as a screwdriver, move the rotation selector
lever (D) to the left side of the trigger (letter L).
Bit
D
Chuck
Chuck
wrench
D
C
A
Rotation selector lever
in the drilling position
L
A
ENGLISH
B
R
7