Publicidad
Preparation
Extraction dust hose
• Connect the extraction hose to the dust extraction port of
the machine with an internal diameter of 1 3/8" (35 mm)
(not compatible with Truper brand vacuums).
• Connect the dust extraction hose to a dust extractor or
vacuum cleaner.
Adjusting the cutting angle
• Disconnect the unit from the power source.
• Loosen the 2 screws on the base plate with the Allen
key included.
• Move the shoe forward in order to release it from the
locking pin of the toothed guide of the shoe.
• Adjust the base plate into the desired angle using the
serrated guide in the base plate.
• Tighten the screws back.
• Set the Allen key back in its holder in the power cable
protector immediately after use.
Parallel guide installation
• Loosen the fixing screws with the Hex key (included) and
insert the parallel guide through the base of the guide.
• Set the width of the desired cut according to the scale on
the inside of the base.
• Tighten the fixing screw.
7
Publicidad
