Publicidad
Start up and operation control
• Intermittent Operation:
Connect the plug to the electrical outlet.
Press the switch (A) to start the jig saw operating.
To interrupt its use, simply release the switch.
• Continuous Operation:
Connect the plug to the electrical outlet. Press the switch (A) and lock it by pressing the
Lock-on button (B).
To interrupt its operation, press and then release the switch.
Balancing action control
The balancing action varies the blade cutting angle to
increase the cutting efficiency.
It shall be adjusted with the jig saw unloaded. Do not apply
excessive force on the blade when cutting with the balancing
action. The blade cuts only upwards.
Hard
Material
Straight
Cut
and curved
Speed control
• The tool can be operated at different speeds. These are
selected by adjusting the speed control (D) located on the
top of the tool.
• The number of coats required depends on the material
and working conditions, and it is advisable to determine it
by testing.
It is advisable to reduce the number of strokes when
applying the saw blade while it is in operation against the
workpiece, as well as when sawing plastic and aluminum.
• Refer to the speed guide to select the appropriate one
for the job to be done.
• When working for an extended period
WARNING
of time with a limited number of blades, the power tool
may heat up strongly. Remove the saw blade and let the
power tool run for about 3 minutes at maximum speed to
allow it to cool down.
8
ENGLISH
(C)
Soft
Straight only
Start up
D
Speed guide
Application
Sharp curves
Curve cutting
Curve cutting
Standard cut, Fast cut
B
A
C
Speed
1-2
3-4
4-5
6
Publicidad
