FUXTEC FX-4MS131 Manual De Instrucciones Original página 54

Original Bedienungsanleitung FX-4MS131_de_en_fr_ita_es_rev05
4 Check the gap with a feeler gauge and bend the electrode to the
0.6~0.7mm
correct distance of 0.6 to 0.7mm
5 Check the spark plug washer and screw the spark plug in the first 2-3
threads manually first.
6 Mount the ignition cap back on the spark plug
WARNING
The spark plug must be screwed down tightly; otherwise, the engine runs hot and is damaged.
Maintenance during storage of the machine
If the engine is not to be used for a more extended period, the following maintenance must be carried
out:
1 Open the fuel filler cap and drain the fuel completely. Operate the primary pump until the gasoline is
completely removed from the fuel lines.
2 Open the oil cap and completely drain the lubricating oil as described
3 Adjust the crankshaft to top dead centre (by pulling the starter) to ensure that the air does not cause
corrosion
4 Wipe off all oil stains and clean the cooling fins. Place the device in a clean, dry, and well-ventilated
place.
PROTECTIVE SHIELD-KNIFE SHARPENING.
1. Remove the cutting blade (E) from the protective shield (F).
2. Clamp the knife in a vice. Sharpen the knife with a flat-file.
Please make sure that you keep the angle of the cutting edge.
Move the blade only in one direction.
STORAGE OF A MACHINE
WARNING: If these steps are not taken, plaque will form in the carburettor
and cause difficult starting or permanent damage due to storage.
1. Perform all general maintenance recommended in the maintenance section of
your user manual.
2. Clean the exterior of the machine, drive axle, protective shield, and nylon cutting head.
3. Drain fuel from the fuel tank.
54