Publicidad
Idiomas disponibles
Idiomas disponibles
2-SPEED UNIT OPERATION
Your clipper comes with normal and high speed operation. Use the normal setting
(Setting #1) for most cutting needs. Use the high speed setting (Setting #2) for
cutting through heavy coats.
REMOVING BLADE SET
To remove blade set, first make sure your clipper is switched OFF and UNPLUGGED.
Push down on blade, then gently pull the blade forward (Figure A), and slide it off
the blade hinge. If your blade hinge should snap closed and is flush with the clipper,
use a small standard screwdriver to pry the tongue of the hinge out (Figure B).
NOTE: Hair may accumulate in the front cavity of the housing under the blade. If this
happens, you can clean out the hair by brushing out the cavity with a small brush or
an old toothbrush while the blade is off the clipper.
REPLACING OR CHANGING BLADE SET
To replace or change your blade set, slide the blade bracket onto the hinge of the
clipper (Figure C) and with the clipper turned ON, push the blade towards the clipper
to lock into position.
USER MAINTENANCE
The internal mechanism of your motor clipper has been permanently lubricated by
the factory. Other than the recommended maintenance described in this manual,
no other maintenance should be performed, except by Andis Company, or an Andis
authorized service station. To find an Andis authorized service station near you log on
to andis.com or contact our customer service department: 1-800-558-9441 (U.S.).
BLADE TEMPERATURE
Due to the high speed nature of Andis clippers, please check for blade heat often,
especially on close cutting blades. If blades are too hot, dip the blades only into
Andis Blade Care Plus or apply Andis Cool Care Plus and then Andis Clipper Oil. If
you have a detachable blade unit, you can change your blade in order to maintain a
comfortable temperature; using multiple blades of the same size is popular among
groomers.
CARE AND SERVICING OF YOUR ANDIS CLIPPER BLADES
Blades should be oiled before, during, and after each use. If your clipper blades
leave streaks or slow down, it's a sure sign blades need oil. Place a few drops of
4
Publicidad
