Descargar Imprimir esta página

Husqvarna P4A 18-C70 Instrucciones De Empleo página 10

Ocultar thumbs Ver también para P4A 18-C70:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30
10 |
English
Flashing light red error
indicator
The flashing light of
the red indicator (1)
signals that the
charging process has
been interrupted by a
different fault (see"Battery is not
being charged", page 10).
Troubleshooting
Battery is not being
charged
Battery is not being charged,
the red indicator (1) is
flashing and the green battery
charge indicator (2) is lit up
continuously.
Cause: The charger has identified
an internal error.
Corrective measure: Ensure that
all batteries are fully inserted. Re-
move the mains plug and reinsert.
If the error occurs again, have the
charger checked by an authori-
sed after-sales service centre for
Husqvarna products.
Cause: Battery is not correctly
inserted.
Corrective measure: Insert the
battery into the charger correctly.
Cause: The battery contacts and
charging contacts are dirty.
Corrective measure: Clean the
battery contacts and charging
contacts; e.g. by inserting and re-
moving the battery several times.
Cause: Battery defective
Corrective measure: Replace the
battery.
Battery is not being charged
and the indicator (1) is lit up
red.
Cause: Battery temperature is
outside of the charging range
Corrective measure: Wait until
the battery temperature is back
within the permitted charging
temperature range (0–45 °C)

Publicidad

loading