Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Problem
Has a bent upper
rack after dishes
are loaded.
Cannot close the
door.
Information codes
The Control Panel displays information codes to help you understand what is occurring
with your dishwasher.
Code
Leakage check.
• If a water supply valve connection leak occurs, close the water supply
LC
Water supply check.
• Check if the water supply valve is closed or clogged, or is frozen. Also
4C
Drain check.
• After closing the water supply valve, check whether the drain hose is
5C
High temperature heating check.
• Functional check. With the dishwasher empty, add detergent, and then
HC
52
English
DW7000B_DW80B7070_AA_DD68-00243A-01_EN_FULL.indd 52
Possible cause
The dishes are not loaded
properly.
Auto Release™ Dry mode
is in operation.
valve and go to your house circuit breaker panel, set the dishwasher's
circuit breaker switch to off, and then contact the installer to fix.
If the problem continues, contact an authorized Samsung service center.
check if the supplied water pressure is less than required.
If the problem continues, close the water supply valve, and then contact
an authorized Samsung service center.
clogged or folded. Also, check whether the drain hole inside the sump is
clogged.
If the problem continues, contact an authorized Samsung service center.
run a cycle. If the problem continues, go to your house circuit breaker
panel, set the dishwasher's circuit breaker switch to off, and then contact
an authorized Samsung service center.
Solution
• Load your dishes as recommended.
(See page 18.)
• Once the door opens in the Auto
Release™ Dry mode, the door cannot
be closed manually for the next
2 minutes. You may close the door
after 2 minutes.
Action
2023-02-24
3:45:54
Publicidad
