Stanley STHT77065 Manual Del Usuario página 6

Measuring Volume
E
You can measure the volume of a room
or object.
1. Press the gear button (Figure A
times to show the volume icon on the
display window (Figure C
Measure the width.
1. Point the top of the tool at one side of the
target (room or object).
2. Position the tool at one end of the target
and point the laser dot across the width.
1
(Figure H
tool if you are measuring from the top of
the tool.)
3. Press to display the width measurement at
the top of the display window.
Measure the length.
1. Position the tool at one end of the target
and point the laser dot across the length.
2
(Figure H
tool if you are measuring from the top of
the tool.)
2. Press On to display the length
measurement on the second line of the
display window.
Measure the height.
1. Positon the tool at one end of the target
and point the laser dot across the height.
3
(Figure H
tool if you are measuring from the bottom
of the tool).
2. Press On to display the height
measurement on the third line of the
display window.
View the Volume measurement at the bottom
of the display window (Figure C
Adding Measurements
You can add two measurements to get a total
measurement of the two distances.
6
4
3
).
) shows where to position the
) shows where to position the
shows where to position the
3
).
1. Press gear button (Figure A
the addition icon on the display window
(Figure C
2. Press On button (Figure A
) three
the distance from the tool to the wall or
object.
3. Press the On button to record the first
measurement on the top line.
4. Point the laser (Figure A
next wall or object.
5. Press the On button to record the second
measurement on the middle line.
6. View the total of the two measurements
at the bottom of the display window
(Figure C
Subtracting Measurements
You can subtract one measurement
from another.
1. Press gear button (Figure A
the subtraction icon on the display
window (Figure C
2. Point the laser at the top of the tool laser
(Figure A
whose distance you need to measure.
3. Press On button (Figure A
the distance from the tool to the wall or
object.
4. Press the On button to record the first
measurement on the top line.
5. Point the laser at the top of the tool
toward the next wall or object.
6. Press the On button to record the second
measurement on the middle line.
7. View the difference of the two
measurements at the bottom of the
display window (Figure C
NOTE: If Second measurement is larger
than first: IC 601 will be displayed
for a negative number. Please switch
measurement points so first measurement
is larger than second.
4
) to show
4
)
3
) to measure
1
) toward the
3
).
4
) to show
3
).
1
) toward the wall or object
3
) to measure
3
).