TruVision TVPA-S01-1202-360-G Guia De Instalacion página 13

EN
Installation environment
When installing your product, consider these
factors:
• Electrical: Install electrical wiring
carefully. It should be done by qualified
service personnel. Always use a proper
PoE-af switch or a 12 VDC UL listed
Class 2 or CE certified power supply to
power the camera. Do not overload the
power cord or adapter.
• Ventilation: Ensure that the location
planned for the installation of the camera
is well ventilated.
• Temperature: Do not operate the camera
beyond the specified temperature,
humidity, or power source ratings. The
operating temperature of the indoor
camera is between -40 °C to +60 °C. The
operating temperature of the outdoor
camera is between -40 °C to +60 °C.
Humidity 95% or less (non-condensing)
for both cameras.
• Servicing: Do not attempt to service this
camera yourself. Any attempt to dismantle
or remove the covers from this product
will invalidate the warranty and may also
result in serious injury. Refer all servicing
to qualified service personnel.
Cleaning: Do not touch the sensor
•
modules with fingers. If cleaning is
necessary, use a clean cloth with some
ethanol and wipe the camera gently.
Unpacking
Check the package and contents for visible
damage. If any components are damaged
or missing, do not attempt to use the unit;
contact the supplier immediately. If the unit
is returned, it must be shipped back in its
original packaging.
Installing the camera
See pages 1 to 10.
To prevent injury, the camera must be
securely attached to the ceiling or wall in
accordance with the installation instructions.
The ceiling must be strong enough to be able
to withstand more than eight times the weight
of the camera and its accessories.
Ensure that the power is disconnected before
you wire, install, or disassemble the camera.
Important: When mounting the camera to a
wall, ensure that the 'UP' reference on the
camera base is pointing upwards.
When re-attaching the camera cover ring,
ensure that the opening on the side of the
cover near the cover screw is not up against a
wall or ceiling. You will need to have access to
that area when removing the camera cover.
Camera description
See page 2.
1. Cover
2. MIC
3. Micro SD card slot
4. Reset button
5. Base
6. Speaker
7. Three IR illuminators
8. Camera cover ring
9. PoE+ & network port
10. 12 VDC
11. Alarm input (pins IN and G), Alarm output
(pins 1A and 1B)
12. RS-485 port
13. Audio out
14. Audio in
Supported accessories
(They are not supplied with the camera)
• TVF-BBM: TruVision 360° camera back
box
EN
11