Descargar Imprimir esta página

Desoutter FCT30 Manual De Instrucciones página 7

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 51
Product Instructions
Installation
Installation instructions
FCT is designed to measure clamp preload and relative torque applied to joints.
Select the correct size of FCT, which is within the maximum torque capacity of the tool used.
Make sure to install the FCT base on a stable horizontal working station to avoid/minimise any vibration or movement of
the system. Install the FCT with four fixing bolts M5x18 (see figures below):
NOTICE! Tighten the four M5 fixing bolts up to approximately 5.5 Nm.
NOTICE! Do not install the FCT near any surface that could limit its action range. Respect the following guidelines in
order to make sure that there is a clearance between the transducer cable and any external surface:
FCT30/60
Make sure that the operating area of the FCT is circular with a diameter of 600 mm (with the center on the main screw
of the FCT) – see the figure above.
Connect the FCT to the measuring instrument (Desoutter Delta 1D, 6D or 7D minimum firmware version 2.8x) through
the transducer cable.
For more information about the Desoutter Delta, refer to "Delta User Guide" (Desoutter User Guides are available at
http://www.desouttertools.com/resource-centre).
09/2020
7 / 216

Publicidad

loading

Este manual también es adecuado para:

Fct6061593524906159352500