Desoutter FCT30 Manual De Instrucciones página 8

Product Instructions
Operation
Configuration instructions
Remove the top cover of the FCT.
In sequence, vertically align the main screw (1) and the adapter (2) on the
ratchet socket of the FCT.
NOTICE! Before use, make sure that the oil 75W-90 has been
correctly added to the FCT.
Operating instructions
Operate the tool on the joint making sure to align the tool/transducer to avoid any influence from side forces which may
affect the measuring result. Failure to comply with this requirement and to exceed the maximum rated torque may cause
irreversible damage to the FCT.
See Spare Part List for recommended screws.
NOTICE! Always loosen the screw when the FCT is not in use. Keeping the screw tightened for a prolonged time can
cause permanent damage to the transducer.
NOTICE! Replace the FCT screw and washer at intervals of 30000 tightenings or if excessive wear is detected.
Desoutter Delta shows the total number of tightenings of the main screw. For more information about the Desoutter
Delta, refer to "Delta User Guide" (Desoutter User Guides are available at
centre).
NOTICE! Perform a manual check of the FCT nutsert at intervals of 30000 tightenings. The manual check consist in a
bare-handed tightening to check for anomalous friction. Replace the FCT nutsert if the manual check fails. Desoutter
Delta shows the total number of tightenings of the main screw. For more information about the Desoutte r Delta, refer to
"Delta User Guide" (Desoutter User Guides are available at http://www.desouttertools.com/resource-centre).
NOTICE! Replace the FCT oil 75W-90 at intervals of 60000 tightenings. Dispose of the waste oil in accordance with
local regulations. Desoutter Delta shows the total number of tightenings of the main screw. For more information about
the Desoutter Delta,
http://www.desouttertools.com/resource-centre).
09/2020
refer to "Delta User Guide" (Desoutter
8 / 216
http://www.desouttertools.com/resource-
User Guides are
2
1
available at