Ruby S 10-20 W Manual De Instrucciones página 25

INSTRUCTIONS MANUAL
INSTALLING THE DEVICE
The heater shall be installed and used according to the safe standard.
To avoid all dangers, follow the safety instructions.
- The installation must be done by the service agent or similarly qualified persons in order to avoid a
hazard.
- Important! Make sure that there are no electric cables or other installations (for example water pipes)
near the drill holes. Make sure that the appliance is securely and vertically fitted to the wall.
Get two holes on the wall 2 m above the floor and near the corner more 25 mm, be sure to make the
diameter just as same as the expanding pipe. Fix two screws on the expanding pipe, keep the tips of the
screws out for 10mm, and hang up the machine after the screws are fixed enough.
OPERATION INSTRUCTIONS
1. Before inserting the plug into an electrical outlet, make sure that the electrical supply in your area
matches that on the rating label on the unit.
2. Carefully remove the heater from the plastic bag and the carton.
3. Place the heater on the wall, setting the master button to "-"position. Plug the cord set into a AC220-
240V~ electrical outlet,with "BEE" sounds the "Power"light is on and the heater will shows the default
temperature 20 ºC, it will twinkle 5 seconds.
1 · HEATING PERPARE
Set time
Before turn on the heater, set the time as right time. Press remote control
it shows current Room temperature.
25
RUBY S 10-20 W
button, light on control panel,