Eico AIDA 60 - LINK Manual De Instrucciones página 23

RADIO CONTROL
ATTENTION:
The hoods with the standard remote control are already configured.
For optional and/or replacement remote controls it is necessary to start the activation
process:
1. Press and hold the + button on the hood, (while it is off) until the LED starts flashing
(release button)
2. When flashing, press on / off light on the remote control within 1 minute.
Control buttons:
> One button for turning the lights on and off.
> One button for turning on at 2nd speed and for turning the motor off.
> Two buttons + and - for increasing and decreasing the motor speed. At the 4th motor
speed (intense) the led flashes and after 5 minutes the 2nd speed is automatically set.
> A TIMER button for turning the motor off after 10 minutes.
USE AND MAINTENANCE
Before beginning any sort of cleaning or maintenance work, turn power off to the hood by turning the main
switch to 0 (OFF).
Changing the light bulbs
LED spotlight replacement should only be carried out by qualified technicians using only original spare parts.
Cleaning the metal filters:
The metal filters fitted in the hood should be washed every 2-3 months, de-
pending on how much the hood is used, using hot water and a liquid detergent
that is not too aggressive. The metal filters can be removed by the special
handle, unhooking the front part of the filter and pulling it downwards
Carbon filters
If the hood is used with an internal recycle filtering system, then active carbon filters must be used. The active car-
bon in the filters traps the cooking smells. To remove and change the filters, refer to fig.
POLYESTER carbon filters cannot be reused or washed and must be periodically changed (every 4 months if the hood
is used for 2 hours every day). Saturate filters could be a fire hazard.
Depending on the hood model, the carbon filters are round or rectangular.
LONG LIFE carbon filter can be cleaned and reactivated. The filter should be cleaned every other month if used nor-
mally. The filter is best cleaned in a dishwasher at the highest temperature using normal washer detergent. The filter
should be washed on its own to prevent particles of food from fastening in it and then causing an unpleasant smell
later on. To reactivate the carbon the filter should be dried in the oven. Chose upper/ lower heat and maximum 100 °
C and try the filter for 10 minutes. When the filter has cooled down, put it back in the hood.
EN - 20