cosori CFD-N051-W Manual Del Usuario página 9

USING YOUR DEHYDRATOR
Operation
Note: Use the dehydrator in a warm, dry room. Depending on humidity in the air and moisture in the food,
dehydration time may vary.
1. Place food on trays. The trays can hold
up to 0.5 kg (1.1 lb) of food. Place food on
the bottom tray first, and use the top tray
last. Be careful not to overload the trays.
Note: The trays can be rotated to provide more
spacing between each tray. [
2. Plug in. The dehydrator will beep, and
the display will show "00:00".
3. Press TEMP/TIME
temperature. The temperature will blink
on the display, and the
+
will light up. Use
temperature (35–75°C).
Note: Temperature changes in 1°C increments.
+ -
Press and hold or to change the temperature
rapidly.
4. Press TEMP/TIME
The time will blink on the display, and
+ –
the and buttons will light up. Use
–
and to change the time (0:30–48:00).
Note: Time changes in 30 minute increments.
–
+
Press and hold or to change the temperature
rapidly.
Figure 1.1
Figure 1.1 ]
to choose
+ –
and buttons
–
or to change the
again to choose time.
+
5. Press START/STOP
The dehydrator will start heating.
START/STOP
will stay lit, and the other
buttons will turn off. Temperature and
time will cycle on the display every 3
seconds.
Note: If you press START/STOP
dehydration, the timer countdown will reset and the
dehydrator will go into standby mode.
6. Optionally, you can change the time
and temperature at any time by pressing
TEMP/TIME.
7. When the timer finishes, the display will
show "End" and heat will turn off. The
dehydrator will beep 5 times, and the
fan will continue running for 5 seconds
before stopping.
Note: The dehydrator will always remember your
previous temperature and time settings.
to start dehydrating.
again to stop
EN
9