Publicidad
Idiomas disponibles
Idiomas disponibles
Gas Connection
9.07 kg (20lb) Propane Tank
LP Gas:
IMPORTANT: A 9.07 kg (20lb) propane tank must be
purchased separately.
IMPORTANT: The gas pressure regulator/hose assembly
supplied with the grill must be used. Replacement gas pressure
regulator/hose assembly specific to your model is available
from your outdoor grill dealer.
To Connect the 9.07 kg (20lb) Propane Tank:
Check that the 9.07 kg (20lb) propane tank is in the "OFF"
1.
position. If not, turn the valve clockwise until it stops.
2.
Check that the 9.07 kg (20lb) propane tank valve has the
proper type-1 external male thread connections per ANSI
Z21.81.
Check that the burner control knobs are in the "OFF"
3.
position.
4.
Remove any debris and inspect the valve connections,
port, and gas pressure regulator/hose assembly for
damage.
NOTE: Always keep the propane tank at 90°(upright)
orientation to provide vapor withdrawal.
A
A. Gas pressure regulator/hose assembly
B. 9.07 kg (20lb) propane tank
5.
6.
7.
8.
9.
To Disconnect the 9.07 kg (20lb) Propane Tank:
1.
2.
3.
4.
5.
B
9
Using your hand, turn the gas pressure regulator/hose
assembly clockwise to connect to the 9.07 kg (20lb) LP
gas fuel tank as shown.
Hand tighten only. Use of a wrench could damage the
quick coupling nut.
A. Gas pressure regulator/hose assembly
B. 9.07 kg (20lb) propane tank
Make sure that the tank valve connection device properly
mates with the connection device attached to the inlet of
the pressure regulator.
Open the tank valve fully by turning the valve
counterclockwise. Wait a few minutes for gas to move
through the gas line.
Before lighting the grill, test all connections by brushing on
an approved noncorrosive leak-detection solution. Bubbles
will show a leak.
If a leak is found, turn the tank valve off and do not use the
grill. Contact a qualified gas technician to make repairs.
Go to "Check and Adjust the Burners" section.
Check that the burner control knobs are in the "OFF"
position and the grill is cool.
Check that the 9.07 kg (20lb) propane tank is in the "OFF"
position. If not, turn the valve clockwise until it stops.
Using your hand, turn the gas pressure regulator/hose
assembly counterclockwise to disconnect to the 9.07 kg
(20lb) LP gas fuel tank as shown.
Hand loosen only. Use of a wrench could damage the
quick coupling nut.
Place dust cap on cylinder valve outlet whenever the
cylinder is not in use. Only install the type of dust cap on
the valve outlet that is provided with the cylinder valve.
Other types of caps or plugs may result in leakage of
propane.
A. Gas pressure regulator/hose assembly
B. 9.07 kg (20lb) propane tank
Publicidad
