Publicidad
Idiomas disponibles
Idiomas disponibles
Powering the transmitter
Connect the power supply unit to the transmitter with the yellow "5V DC
1.5A" power socket. Then plug the power supply unit into an electrical
mains outlet.
Using the rechargeable battery
Insert the supplied battery into the receiver, until it clicks into place (the
battery only fits one way)
Charge the receiver completely and without interruption before first use. A
complete charge will take about 2 hours.
The battery status on the receiver lights up red when the battery level is low.
When system is in use and the battery in the receiver is low, the status LED
on the receiver flashes RED constantly, and you will hear a beep every 30
seconds. After a few minutes, the receiver will automatically switch off.
To charge the battery, place the receiver in the charging dock of the Trans-
mitter. The LED bar must point upwards, magnets keep the receiver in the
correct charging position.
The charging status LED on the front of the receiver will illuminate red, the
charging status LED will switch to green when the battery is fully charged.
12 English
Publicidad
