turbionaire trend Serie Manual De Instrucciones página 19

9. TROUBLESHOOTING
PROBLEM
The appliance does not switch on.
The impeller does not work.
Devices do not sync.
The remote control
does not work
CAUSE AND SOLUTION
There is no voltage.
Check the main switch and/or the electrical connections.
Check if the unit is running at minimum speed.
This unit is equipped with a manual reset protection system which, in the event of a rotor blockage,
will switch off the engine. To restore normal operation, proceed as follows:
disconnect the unit from the mains electricity supply;
remove the cause of the blockage (only qualified personnel);
reconnect the unit to the mains electricity supply.
The unit will only resume normal operation if the protection system does not detect any additional
faults. If the fault persists, contact the client support service.
Disconnect and reconnect to the power source.
Check the condition of the batteries.
19