Publicidad
MILLIAMP CLAMP METER
6-3 DCV Measurement:
V
Turn the dial to the
range. Connect the red test lead to
the "+" terminal and the black lead to the "COM" terminal.
Place the red and black test leads at both the positive and
negative points to be measured. The display will show the
value of the measurement being taken.
6-4 Continuity Test with Buzzer:
Turn the dial to the
Ω range. Connect the red test lead to
the "+" terminal and the black lead to the "COM" terminal.
Place the red and black test leads at both the positive and
negative points to be measured. The buzzer will sound when
the resistance is less than 45 Ω.
NOTE:
When measuring continuity, all power to the circuit or cable
being tested MUST be turned off to prevent damage to the
user or the clamp meter.
Short Circuit
Open Circuit
I
13
KING INNOVATION
Publicidad
