Publicidad
Idiomas disponibles
Idiomas disponibles
Electrical safety instructions
The power tool is double insulated, which means
that all external metal parts are insulated from
the electrical components. Therefore, in accordance
with EN 60745 standard, no grounding is required.
However, double insulation does not replace normal
safety precautions, which must be observed when
operating the power tool.
Do not expose the power tool to rain, or use it in wet or
damp conditions. The presence of water in a power tool
increases the risk of damage and electric shock to the
user.
Only hold the power tool by its insulated surfaces,
which prevent electric shock if the power tool comes
into contact with hidden wires or power cord during
operation.
Do not use power tools in explosive atmospheres,
such as in the presence of flammable liquids,
gases or dust. Power tools create sparks that can ignite
liquids, gases, or dust.
Before you start operating
Individuals who have not read the instruction manual
and are not familiarized with how to operate the
cordless air compressor must not use it.
To ensure that you work with the power tool safely, you
should take into account a few precautions and
procedures before start-up:
▪ Inspect the power tool before each use. Check that
all attachable accessories are assembled correctly
and in good condition. If there is damage or excessive
wear, replace them.
▪ Under normal operation, the power tool vibrates.
Check that all screws are properly tightened. Regular
inspection is important to ensure safety issues and
the performance of the power tool;
▪ After the accessories' assembly and before using the
power tool, test it at full speed with no load for a
while;
▪ Check that the safety devices are in perfect condition
and function properly. Never use the power tool if
the safety devices are missing, inhibited, damaged or
worn out;
▪ If the ON/OFF switch is damaged or does not allow
the operation of the tool to be controlled, it must be
repaired or replaced in order to prevent any
accidental start;
Make all adjustments and work necessary for the
correct assembly of the cordless air compressor. If you
have any questions or difficulties, contact your official
distributor.
While operating
Keep third parties from the power tool's area of
operation. Never work while animals or people,
especially children, are in the danger zone.
Keep the work area clean, organized and well lit (250 to
300 lux), thus decreasing the risk of accidents.
Always wear personal protective equipment and
clothing. Wearing a visor or goggles, dust mask, hearing
protection, anti-slip safety shoes, long-sleeved clothing,
gloves and helmet properly reduces the risk of injury.
Clothing worn during the appliance operation must be
adequate, tight and closed, for example, a work boiler
suit. Do not wear loose clothing or jewelry. Keep hair,
clothing and gloves away from moving parts.
25
Publicidad
