Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
Battery
1. Insert the battery (6) on the groove and slip it all the
way until you hear a "click" noise from the
lock/unlock button (7). At this point, the battery is
locked in place;
2. To remove the battery, press the lock/unlock button
and pull out the battery;
Use VITO 20V lithium-ion batteries.
Charging the battery
1. Place the battery in the charger in the same way as
you would place it in the appliance;
2. Plug the charger into the socket and let it charge.
Sometimes at the end of charging, both the battery and
the charger can be hot, which doesn't mean they
malfunction.
Let the battery cool down before putting it in the
cordless air compressor.
Air hose
1. Loosen the air hose nut (2) (but do not remove the
nut);
2. Insert the hose thread into the connector;
3. Retighten the nut.
Inserting and changing accessories
Remove the battery before fitting or changing
accessories.
1. After raising the air chuck lever, insert the accessory
suitable for the work to be performed;
2. Lower the lever to lock the accessory in place;
3. To remove the accessory, lift the lever and remove it.
OPERATING INSTRUCTIONS
When operating the cordless air compressor, you must
consider some use procedures:
▪ Hold the appliance with both hands;
▪ This power tool was not designed for continuous
operation. It can be used continuously for a
maximum of 6 minutes;
▪ If the appliance overheats, remove the battery and
allow it to cool down before using it again;
▪ Wear ear plugs while operating the cordless air
compressor. Exposure to noise can cause hearing
loss;
▪ If the air hose is not connected to any object, the
display will show "0".
▪ Switch off the cordless air compressor immediately if
any of the following problems occur:
- Grease leakage through the ventilation slots;
- Damage to the cordless air compressor housing;
- Damage to the "ON/OFF" switch;
- If you sense smoke or burning smell;
Selecting pressure and pressure unit
You can choose between two pressure measurement
units: bar or psi.
To select which one you want, simply press the
"ON/OFF" switch (10), with the display (8) on.
Press and hold the "+" (11) or "-" (9) push-button until
the display starts flashing.
Then press the "+" or "-" button to set the desired
pressure.
Once the set pressure appears on the display, do not
press any button. After about 3 seconds, the new
pressure is set.
Start and stop
1. Press the "ON/OFF switch" (10);
2. Set the desired pressure;
3. Insert the suitable accessory for the task to be
performed;
4. Connect the air hose and adaptors to the object to be
inflated;
5. Press the trigger (3) until the appliance stops
inflating;
6. Disconnect the accessory from the object by pulling
it.
The cordless air compressor cuts-out automatically
when preset pressure has been reached.
Accessories
(15) - For inflating pool floats or similar;
(16 and 17) - Universal adaptor for inflating balloons or
similar;
(12) - Ball needle;
(13 and 14) – Valve adaptors;
27
Publicidad
