Hilti DX 462 CM Manual De Instrucciones página 21

ORIGINAL OPERATING INSTRUCTIONS
DX 462 CM / DX 462 HM powder-actuated tool
It is essential that the operating instruc-
tions are read before the tool is operated
for the first time.
Always keep these operating instructions
together with the tool.
Ensure that the operating instructions
are with the tool when it is given to other
persons.
Description of main parts
@ Exhaust gas piston return unit
; Guide sleeve
= Housing
% Cartridge guideway
& Powder regulation wheel release button
( Power regulation wheel
) Trigger
+ Grip
§ Piston return unit release button
/ Ventilation slots
: Piston*
· Marking head*
$ Marking head release button
* These parts may be replaced by the user/operator.
Contents
1. Safety rules
2. General information
3. Description
4. Accessories
5. Technical data
6. Before use
7. Operation
8. Care and maintenance
9. Troubleshooting
10. Disposal
11. Manufacturer's warranty – DX tools
12. EC declaration of conformity (original)
13. CIP approval mark
14. Health and safety of the user
1. Safety rules
1.1 Basic safety instructions
In addition to the safety rules listed in the individual
sections of these operating instructions, the following
points must be strictly observed at all times.
1.2 Only use Hilti cartridges or cartridges of equiva-
lent quality
The use of cartridges of inferior quality in Hilti tools may
lead to build-up of unburned powder, which may explo-
de and cause severe injuries to operators and bystan-
ders. At a minimum, cartridges must either:
a) Be confirmed by their supplier to have been suc-
cessfully tested in accordance with EU standard EN
16264
NOTE:
● All Hilti cartridges for powder-actuated tools have
been tested successfully in accordance with EN 16264.
● The tests defined in the EN 16264 standard are system
tests carried out by the certification authority using
specific combinations of cartridges and tools.
The tool designation, the name of the certification aut-
hority and the system test number are printed on the
cartridge packaging.
or
b) Carry the CE conformity mark (mandatory in the EU
as of July 2013).
See packaging sample at:
www.hilti.com/dx-cartridges
1.3 Use as intended
The tool is designed for professional use in the marking
of steel.
Page
15
17
1.4 Improper use
17
● Manipulation or modification of the tool is not per-
18
missible.
19
● Do not operate the tool in an explosive or flammable
19
atmosphere, unless the tool is approved for such use.
20
● To avoid the risk of injury, use only original Hilti char-
21
acters, cartridges, accessories and spare parts or those
of equivalent quality.
23
● Observe the information printed in the operating
25
instructions concerning operation, care and mainte-
25
nance.
25
● Never point the tool at yourself or any bystander.
26
● Never press the muzzle of the tool against your hand
26
or other part of your body.
en
15