Publicidad
Idiomas disponibles
Idiomas disponibles
Operate the charger only with
the appropriate original battery-
packs. Charging other battery-
packs may result in injuries and
risk of fire.
Avoid mechanical damage to
the charger. This can result in
internal short circuits.
Do not operate the charger on a
combustible surface (e.g. paper,
textiles). Risk of fire due to
heating during charging.
If the supply cord of this
appliance is damaged, it must
be replaced by the
manufacturer, its service agent
or similarly qualified persons in
order to avoid a hazard.
Do not charge non-rechargeable
batteries in the charger. This
could damage the appliance.
The charger is suitable
for indoor use only.
Note: This charger is suitable
only for the battery pack type
Parkside Perfomance 20 V.
Before use
Charging the battery pack
CAUTION! Always pull out the plug of charger
before removing or connecting the battery pack
to the charger.
9
Never charge the battery pack
ambient temperature is below 10°C or above
40°C.
Connect the battery pack
charger
(see Fig. B).
14
The green LED flashes briefly and then expires
when the battery is empty. The red LED glows
permanently while loading.
During charging operations, only red charge
status LED
glows up.
15
The green charge status LED
red charge status LED
charging process is completed
Red LED flashes : Battery pack is defective
Green LED flashes : Battery pack is too cold or
too hot
Attaching / Disconnecting the
battery pack
Inserting the battery pack:
Push and allow battery pack
connection slots completely and be clicked to
it. (see Fig. C).
Removing the battery pack:
Press the release button
pull the battery pack
Fig. D).
Checking the battery level
Press the battery level button
charge level of the battery pack (see Fig. E).
The status / remaining charge will be shown on
the battery level indication lights
3 red lights glow = maximum charge level
2 red lights glow = medium charge level
1 red lights glows = low charge level
Changing the blade (see Fig. F)
Always wear protective gloves when
handling the saw blade in order to
avoid cutting yourself.
when the
9
to the fast
9
lights up while
16
turns off that the
15
into the tool's
9
downward and
11
from the tool (see
9
to check the
10
.
12
GB/IE
27
Publicidad
