Publicidad
Idiomas disponibles
Idiomas disponibles
EN
NOTE: The three strainers cannot be changed while the device is operating. The juice strainer
is used to extract juice, the jam strainer is used to make ketchup only, and the frozen food
strainer is used to make frozen dishes. Select the appropriate strainer based on what you
require.
3. Assemble the jar lid correctly. First, add the jar lid, making sure the " " symbol aligns with
the same " " symbol on the jar: see page 3 fig. D1.
Then, turn the jar lid clockwise until the " " symbol on the jar lid aligns with the " " symbol
on the jar. (D2).
After that, press the clasp inward to lock the jar lid tightly (D3). The jar lid must in the correct
position, otherwise the device will not work. Finally, add the food pusher to the jar lid (D4).
4. Place your juice container below the juice outlet and the waste container below the waste
outlet: see page 3, fig. E. The Juicer is now ready to operate.
Note: When you need to move the whole appliance, please hold it by the motor unit instead
of the jar lid to avoid accidents.
USING YOUR JUICER
1. Before plugging the power cord into the outlet, make sure the power switch is in the "O"
position. The power switch has three settings:
"I" indicates "ON". Push the power switch to the "I" position to activate the motor and start
juicing.
"O" indicates "OFF". Press the power switch to the "O" position to switch off the machine.
"R" stands for reverse rotation, which is only used when something is stuck and needs to be
removed.
2. Make sure the juice container and the waste container are placed in the correct position.
3. Cut fruit and vegetables into smaller pieces, e.g., carrots should be cut into thin slices 15
mm×15 mm before being placed in the machine.
NOTE:
A) Please remove any pits before juicing.
B) Do not process coconut, sugarcane or similarly hard food, as this may damage the motor.
C) Processing hard fruit or fibrous and starchy vegetables is not recommended.
D) The peel and pits should be removed from oranges, lemons, grapefruits, and melons.
4. Add fruit or vegetables at an even pace. Do not load food too quickly and do not load too
much food at a time.
NOTE:
Use the food pusher to remove any blockage should the jar lid be blocked by ingredients.
5. Connect the appliance to the power supply, and then press the power switch to the "ON"
position. The appliance will start working. After a few minutes, the juice will drain out.
6. If the machine becomes stuck while operating, first press the power switch to the "O" posi-
tion and then press the reset switch at the bottom of the unit: see page 3, fig. F.
16
Leave the power switch in the "R" position for a few seconds and then try to operate the
device again. If the reverse function is not working, switch off the machine and reassemble
following the instructions given. Once reassembled, try switching on the machine.
7. Once the juice container is full (maximum capacity is 400 mL) or once you have finished
juicing, switch the power switch to the "O" position and empty the juice container and the
waste container before continuing.
NOTE:
• The maximum operating time should be less than 15 minutes. There should be a minimum
rest time of 30 minutes between two continuous cycles.
• Do not add too much food at a time. While operating, and once the juice container is full,
you should stop the appliance and empty the waste container before the next cycle.
• While operating, if the interlock switch between the jar lid and the motor unit is disconnect-
ed, the motor will stop to avoid any danger.
• When extracting juice, the waste should be removed as quickly as possible so that the jar,
the grinding head and the jar lid can be easily separated.
• Once finished, enjoy your juice in time to get the best flavor. Any unused juice should be
stored in the refrigerator.
CAUTION! Do not turn the power switch straight from "I" to "R" or from "R" to "I"
at any time during operation. If necessary, first press the power switch to the "O"
position and bring the unit to a complete stop, then turn the power switch from "I" to
"R" or from "R" to "I".
CAUTION! Do not operate the unit while empty to avoid damaging the grinding
assembly (including the grinding head and the strainer).
CAUTION! Do not place your fingers or any foreign objects inside the feed opening
while the device is operating.
TROUBLESHOOTING
Some issues that arise can be solved by the user. If the problem persists after having tried the
following solutions, please contact Prozis customer service.
PROBLEM
CAUSE
The appliance is not working
The appliance not plugged in
The wall outlet is not energized
EN
SOLUTION
Insert the plug into the wall outlet
Check the fuses and the circuit breaker
17
Publicidad
