Publicidad
Idiomas disponibles
Idiomas disponibles
optimal results, the steam settings should be
used with the following temperature settings.
•
Low steam: blends
•
Medium steam: wool
•
High steam: cotton or linen
7.
When finished ironing, turn the temp. dial to the
minimum setting
8.
Stand the iron on its heel rest and allow it to cool off.
A D D I T IO NA L FE AT UR ES
Burst of Steam
Use for ironing in the vertical and horizontal position.
Press the Burst of Steam button to generate a burst
of steam. For best performance, leave several seconds
between bursts.
Spray Mist
Press the Spray mist trigger to generate a spray of
water. Spray Mist is used to dampen tough wrinkles
while dry or steam ironing. Do not spray silk.
3-way Auto Shut Off
The iron will automatically shut off after 30 seconds of
inactivity if left on its soleplate or side. If left vertically
on the heel rest, it will shut off after 8 minutes. When
the iron is in Auto-Shut Off, the red light under the
handle will blink. Simply move the iron to take it off
stand-by.
6
D3300_D3300C_IB-hz_ESF_29209_revB_extrapages.indd 6
D3300_D3300C_IB-hz_ESF_29209_revB_extrapages.indd 6
and unplug from the outlet.
I RONI NG T IP S A ND TRICKS
•
The iron can be filled with ordinary tap water; if
your water is hard, you may want to use 50 percent
distilled water and 50 percent tap water.
•
For optimum performance, allow the iron to stand
on the heel rest about two minutes after filling
before beginning to iron.
•
If you're unsure of the fabric's content, test a
small area (on the inside seam or hem) before you
proceed to iron the entire garment or cloth.
•
Whenever ironing a garment with mixed fabrics,
select the fabric setting for the most delicate
fabric. For example, when ironing a shirt that is 65%
cotton and 35% polyester, use the "blend" setting.
•
Whenever temperature settings are changed to a
higher or lower temperature, allow the iron to stand
1–2 minutes to allow heat up or cool down. Test
garment by pressing a small hidden area to make
sure temperature of iron is correct.
6/6/22 2:59 PM
6/6/22 2:59 PM
Publicidad
