Sauder North Avenue Serie Manual Del Usuario página 5

Step 1
å
Assemble your unit on a carpeted floor or on the empty
carton to avoid scratching your unit or the floor.
å
Fasten the BRACES (B and C) to a END (A). Tighten four
1-3/16" HEX HEAD SCREWS (7) using the L-WRENCH (4).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
B
A
1-3/16" HEX HEAD SCREW
(4 used in this step)
426016
B
Straight edge
7
www.sauder.com/service
C
C
4
Just think. The sooner
you do this, the sooner
you do something else.
These holes must be here.
Page 5