Publicidad
Step 11
IMPORTANT: You will need someone's help in this step.
å
Fasten the LIFT TABLE MECHANISMS (9) to the ENDS (E and F).
å
Use fourteen 1/2" PAN HEAD SCREWS (16) through the LIFT TABLE
MECHANISMS (9) and into the holes in the ENDS as shown in the
enlarged diagram.
NOTE: Be careful when lining up the holes in the MECHANISMS
å
with the holes in the ENDS as to not damage any parts. You
should start each SCREW a few turns before completely tightening
any of them.
Page 16
F
www.sauder.com/service
1/2" PAN HEAD SCREW
(14 used in this step)
This hole is used
in the next step.
E
16
9
426023
Publicidad
