Publicidad
Idiomas disponibles
Idiomas disponibles
6
GETTING STARTED
Charge
Fill
Insert
Eject
ON
ON
OFF
OFF
Power ON
Water
ON
ON
High
OFF
• 2 • 4 • 6 • 8 • 10
Low
Charging Unit Prior to First Use
If a USB charger is not provided, a user supplied USB charger with the following
specifications is required to charge this product: USB Type-A, Rated Output: 5.0
VDC, 1.0 A. Ensure contacts on BOTH the cable and unit are clean and dry
before connecting the charger. Plug the USB-charger into a wall outlet and connect
the magnetic charger cable to the unit. The charge indicator on the unit will glow while
charging and then begin to flash momentarily every 3 seconds when the unit is fully
charged. A full charge will last for approximately 4 weeks when unit is used once a day
for one minute a day. When the batteries are in need of charging (approximately 30%
charge left) the charge indicator light will blink 3 times quickly to indicate that the user
should consider recharging the unit. A complete recharge will take 4.5-5 hours. If you
use your Water Flosser once a day or less, it is recommended that you charge it every
3-4 weeks. If you use it twice a day or more, charge the unit more frequently.
Preparing the Reservoir
Remove the reservoir, lift the reservoir lid, and fill with warm water. Replace the
reservoir over the base and press down firmly and close the lid.
Inserting and Removing Tips
Insert tip into the center of the Water Flosser handle, pressing down firmly until the
tip clicks into place. The colored ring will be flush with the top of the handle if the tip is
correctly locked into place. To remove tip from the handle slide the tip eject button on
the handle.
Prime Unit (First Time Use Only)
Set pressure control on base to high (pressure setting No.10), point the handle and tip
• 2 • 4 • 6 • 8 • 10
into sink. Turn power and water ON until water flows from the tip.
Adjusting the Pressure Setting
Set the pressure control on the base of the unit to the lowest setting (pressure setting
No.1) for first-time use. Gradually increase pressure over time to the setting you prefer
– or as instructed by your dental professional.
Using the Water Flosser
Always place the tip in your mouth before turning the unit power ON. With
water switch on handle in OFF position, turn power on. Lean over sink and slightly
close lips enough to prevent splashing while still allowing water to flow
from mouth into the sink. Turn water switch ON. When finished, turn water
switch and power OFF. During use you can stop the flow of water by sliding the
water switch on handle to the OFF position.
NOTE: Motor will continue to run.
Publicidad
