SGL Flexy Manual De Uso Y Mantenimiento página 27

The setting sequence is the following:
1st Pressure
+3
Red LED on
To exit the temperature setting mode, switch the machine off
then on again.
To enter the dose self-learning mode, switch the machine on
and wait until it reaches the heating temperature, and then:
• Turn OFF the machine
• Turn ON the machine while pressing the button of the
short coffee ➌ coffee. After few seconds the blue LED
starts blinking, at this point release the button.
• Press the button of the short coffee ➌ until you have the
desired quantity, at that point release the button.
• If needed, repeat point 3. for the long coffee ❹;
• Turn OFF the machine. When you will turn ON it again the
right quantities will be dispensed.
2nd Pressure
Standard
Blue and Red LEDs on
DOSE SELF-LEARNING
3rd Pressure
Blue LED on
MANUAL
version
MANUAL
version
EN
-3
18
19
20
27