Publicidad
Step 15
Step
1
D24
K
Groove
Insert the DRAWER SIDES (D24 and D25) at an angle
å
into the slot at each end of the DRAWER FRONT (K).
3
M67
Surface with
HIDDEN CAM
Fasten the DRAWER BRACE (M67) to the DRAWER
å
FRONT (K). Tighten one HIDDEN CAM.
Page 20
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D25
Maximum
Arrow
210 degrees
Minimum
190 degrees
K
VIEW THE T-LOCK BOX VIDEO
2
U n
fi n
s u
i s h
r f a
c e
D24
K
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D723) into the
å
grooves in the DRAWER SIDES (D24 and D25) and
DRAWER FRONT (K).
4
D24
M67
Fasten the DRAWER BACK (D163) to the DRAWER
å
SIDES (D24 and D25) and DRAWER BRACE (M67). Use
five BLACK 1-9/16" FLAT HEAD SCREWS (30S).
418705
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
e d
D723
D25
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(5 used in this step)
D163
Be sure the
D25
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
www.sauder.com/services
Publicidad
