ARDES AR5T1001 Instrucciones Para El Uso página 16

Batteries
Remote control is supplied without batteries; before use remote control
open the batteries holder placed on the back of remote control and insert
2 batteries LR03 1,5V AAA.
To remove batteries, open the batteries holder placed on the back of the
remote control.
ON/OFF Button (A):
• Press On/Off button one time to activate the fan. The unit will start to
operate at lower speed and display show "P1".
• Press On/Off button when unit is on to turn it off. Display show "--"
SWING Button (B):
• Press Swing button when the unit is operating to activate the automatic
left/right oscillation. The "G" indicator light will illuminate on the remote
control. Press again Swing button to deactivate the automatic swing;
"G" indicator light will turn off.
SPEED Button (C):
• Press Speed button when unit is on to select the desired air speed:
low, medium or high. The selected speed is indicated on the LED
display (P1, P2 and P3).
NATURAL MODE Button (D):
• When the unit is operating, you can press natural mode button to enter
into Natural mode, "N1" will show on display to indicate the fan is under
Natural mode. Press it repeatedly to select the fan speed in Natural
mode, "N1", "N2" or "N3" will show on display as per your selection.
Under Natural wind mode, the fan speed will be altered automatically
to mimic natural wind motion.
TIMER Button (E):
• When the unit is operating, you can set the timer to switch the fan
off automatically after the set time. Press Timer button repeatedly to
select the desired time period in hour increments from 1 hour to 9
hours. The LED display will show the setted time (1H, 2H, 3H, 4H, 5H,
6H, 7H, 8H, 9H).
• To deactive the timer press this button till the display show 0H.
NOTES:
1. The fan can be operated through remote control only.
2. The display will turn off after about 5 seconds without operation
3. Operate the remote control within 5m from the unit and within a range
of 45° towards the remote sensor on the main unit.
16