NORAUTO 2372772 Manual página 68

enhanced code, then the "manufacturer control" is displayed on
EN
the screen to select the vehicle for inspection;
POOOO
IOS/SAE reserved
Press Return/Confirm button to return to the previous menu.
1
Delete the code
Caution: Delete the diagnostic code of decoder may not only
delete the code on truck-mounted computer, but also delete
"Freeze Frame" data and the enhanced data of the manufacturer.
In addition. I/M ready monitor status of all vehicle monitors are
reset as non-ready and non-finish state. Do not delete the code
before the technicians check the system completely.
• Implement this function by the key on (KOEO) engine. Do not
start the engine.
If decide to delete the diagnostic code, please press Up/Down
1
button to select "Delete the code" from the Diagnostic menu,
and then press Return/Confirm button.
Read Codes
Erase Codes
l/M Readiness
Data Stream
Freeze Frame
Voltage test
Vehicle Information
A warning message appears, and needs you to confirm.
2
Clear / Reset Emission – Related
Diagnostic Information. Are you sure?
If go on deleting the code, please press Return/Confirm
3
button to delete.
• If the code is deleted successfully, and then "Delete is finished!"
information is displayed on the screen.
• If the code is not deleted successfully, and then "Delete is failed.
Rotate the key in the case of engine is turned off!" is displayed
on the screen. Wait for several seconds or press any button to
return to Diagnostic menu.
If you want to go on deleting the code, press Lp/Down button
4
to select, and press Return/Confirm button. "Cancel the
command" information is appeared. Press any button or wait
for several seconds to return to Diagnostic menu.
67
Review
1/3
Diagnostic Menu
Erase DTC