Pull the drain plug
as the inner plug beneath it) out
of the opening and allow the
water to drain (see fig. J).
Insert both drain plugs
into the opening properly. Once
the product has been connected
to the power supply and the hot
air outlet hose
tached, it can resume operation.
Using continuous
water drainage
If the product is mainly being used
in dehumidification mode, it is pos-
sible to drain the water continuously
and thus empty the water tank au-
tomatically.
Switch off the product and remove
the mains plug
Pull the drain plug
as the inner plug beneath it) out
of the opening and allow the
water to drain (see fig. J).
Problem
The product
won't start.
(as well
8
back
8
has been reat-
13
from the socket.
10
(as well
8
Possible cause
The water tank is full.
The room temperature is
lower than the set tempera-
ture (cooling mode).
Connect a suitable drainage hose
(not included) to the opening.
Place the open end of the drain
hose in a suitable collecting vessel
or drain.
Make sure that the drain hose
leads to the drain as directly
as possible and without kinks
or knots. This way, the water
collected during the dehumidifi-
cation process is automatically
fed into the drain.
Troubleshooting
Some errors are caused by minor
malfunctions and can sometimes be
corrected by the user. If you are still
unable to remedy the problem, con-
tact customer service. Do not repair
the product yourself under any cir-
cumstances.
Solution
Empty the water tank.
Adjust the temperature
setting.
GB/IE
43