EINHELL GC-CL 18/1 Li E Manual De Instrucciones página 11

All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The temperature of the battery is too low. Remove
the battery from the device and leave it at room
temperature for a day. If the error occurs again,
this means that the battery has been completely
depth-discharged and is defective. Remove the
battery from the device. Never use or charge a
defective battery.
5.5 Speed control (Fig. 1)
The device is fi tted with an electronic speed
controller. To use it, turn the speed controller (7) to
the desired position. Use the device only with the
speed which is actually required and do not let it
run at a speed which is faster than necessary.
6. Operation
•
To switch on, press and hold the On/Off
switch (5).
•
To switch off, let go of the On/Off switch.
•
Channel the air stream forward and walk
slowly to blow the material into a pile or to
clear out hard-to-reach places.
7. Cleaning and maintenance
HAZARD!
Always take the battery out of the equipment
before starting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment
immediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may
be aggressive to the plastic parts in the
Anl_GC_CL_18_1_Li_E_SPK7_USA.indb 11 Anl_GC_CL_18_1_Li_E_SPK7_USA.indb 11
EN
equipment. Ensure that no water can get into
the interior of the equipment. The ingress of
water into an electric power tool increases the
risk of an electric shock.
7.2 Maintenance
•
Should the tool experience problems
beyond those mentioned above, let only an
authorised professional or a customer service
shop perform an inspection.
•
There are no other parts inside the equipment
which require maintenance.
8. Disposal and recycling
The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Store the equipment and its accessories out
of children's reach in a dark and dry place at
above freezing temperature. The ideal storage
temperature is between 41°F and 86°F
(5°C and 30°C). Keep the electric tool in its
original packaging.
The reprinting or reproduction by any other
means, in whole or in part, of documentation
and papers accompanying the products is
strictly subject to the express consent of Einhell
Germany AG.
Subject to technical changes.
- 11 -
30.11.2022 14:34:44 30.11.2022 14:34:44