Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
•
Battery tools are always in operating condition.
Therefore, always turn off the light when the light is not
in use or when carrying the machine at your side.
1. Align the bolt the the hole (on the bracket).
2. Insert the bolt into the hole until it kocks into place and
then tighten them with knobs.
3. Do the same operation on the other side.
6.5
REMOVE THE LIGHT HEAD
1. Unlock the right and left knobs.
2. Remove the bolts.
7
OPERATING INSTRUCTIONS
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
7.1
START THE MACHINE
1. Install the battery pack or connect the power source.
2. Press the ON/OFF switch to turn the machine on. The
machine will be turned on at maximum brightness.
3. To reduce the brightness, press the ON/OFF switch again.
Low voltage operation
When the battery pack is less than 5%, the machine will flash
three times with a brightness of 500 lumens.
WARNING
•
Do not continue to press the ON/OFF switch after the
machine has automatically switched off. The battery
can be damaged.
7.2
STOP THE MACHINE
1. Press the ON/OFF switch to turn the machine off.
English
7.3
SWIVEL THE LIGHT HEAD
1. Hold the auxiliary handle and unlock the right and left
knobs.
2. Turn the light head to the necessary position.
3. Tighten the knobs.
8
MAINTENANCE
Remove the battery pack from the machine before
maintenance.
Do not use strong solvents or detergents on the plastic
housing or components.
8.1
CLEAN THE MACHINE
The machine must be dry. Humidity can cause risks of
electrical shocks.
•
Clear the unwanted material out of the air vent with a
vacuum cleaner.
•
Do not spray the air vent or put the air vent in solvents.
•
Clean the housing and the plastic components with a
moist and soft cloth.
9
TECHNICAL DATA
Voltage
Lumens
Run time ( with 24V 4AH
battery )
7
WARNING
WARNING
CAUTION
24 V
2000 lm
Up to 5.5 hours ( high light )
Up to 11 hours ( low light )
EN
Publicidad
